Structure And Function; Overview-Display - ELGO Electronic IZ16E-000 Series Operation Manual

10 Structure and Function

The operation of the device is divided into the parameter level (see section 10.3), the operator level (see section
10.5) and the initialization level.
All operating parameters can be put in through the parameter level (see section 10.3.6).
At the operator level the basic functions are available (depending on the software version).
In the initialization level only the basic operations such as sensor calibration or resetting the unit will run on
default parameters (company setting).
All entries are made solely on the 4 front-mounted buttons or keyboard shortcuts of those, the displays occur via
the integrated LCD.

10.1 Overview-Display

The following display icons or segments of the LCD-display are used in this software version:
4
5
Segments for numeric and text display
1
(including signs, decimal points, fraction display)
2 Symbols for units and display mode
3 Icons for active tool-offsets 1 ... 3
4 Battery-Status Icons
5 REF symbol: unit needs to be referenced
For different applications the symbol may be changed for the unit by parameter (P02), e.g. the „°"- symbol for
angle measurement (see section 10.3.6).
The standardization of the indicator value must be done manually with the corresponding multiplication factor
(P08) and the decimal point (P03) (see section 10.3.6).
In the Inch-mode an additional fraction display is available.
1
33
Structure and Function
3
2