Applications; Magnetic Measurement; Direct Distance Measurement; Angle Measurement 0 - ELGO Electronic IZ16E-000 Series Operation Manual

5 Applications

5.1 Magnetic measurement

5.1.1 Direct Distance Measurement

5.1.2 Angle Measurement 0...<360°
The magnetic tape is glued on a solid ground
(e.g. machine base) along the measuring
distance.
Example 1) Indicator [mm], resolution 0.01mm
 P02=0 / P03=2 / P08=1,0000
Example 2) Indicator [m], resolution 0.001m
 P02=2 / P03=3 / P08=0,01
Example 3) Indicator [Inch], resolution 0.001 Inch
 P02=1 / P03=fixiert=3 / P08=1,0000
The magnetic tape is glued on a solid ground (e.g.
angle stop) along the measuring distance.
To parameterize the indicator or to calculate the
multiplication factor a low angle of 90° is very
suggestive, the reason is that the actual
measurement distance (=angle) is dependent on the
bending radius of the magnetic tape.
Example: Indicator [ ° ], resolution 0.01°
 P02=3 / P03=2 / P08=1,0000 / P09=0
a) Start to the desired mechanical Zero point, then
set the indicator to the reference value.
b) Start to the defined angle position (e.g. low
angle, 90°) and note the actual value at the
indicator (e.g. 471,20)
c) Calculate and enter the multiplication factor:
P08 = Angle/ Display Value
(e.g. P08 = 90° / 471,20 = 0,1910)
 P02=3 / P03=2 / P08=0,1910
10
Applications