Power Supply / Battery Change - ELGO Electronic IZ16E-000 Series Operation Manual

6.1.4 Power supply / Battery change

ADVERT
For a long operating time, the use of commercially branded batteries
is recommended.
If all the battery icons on the LCD-Display are extinguished (see also
section Fehler! Verweisquelle konnte nicht gefunden werden.), a
battery change should be made as soon as possible.
By changing the batteries strictly observe the polarity, take for
orientation the markings on the battery-case!
All data and parameters are obtained at the battery change, apart
from the current actual value.
All components of the series IZ16E-xxx-1-xx,x-x have a built-in battery-holder for a battery of the type
C=LR14=baby cell (supplied).
All components of the series IZ16E-xxx-8-xx,x-1-AG have a built-in battery-holder with bolt down cover for a
battery of the type D=LR20=MONO (supplied).
All components of the series IZ16E-xxx-6-xx,x-x have a pluggable 2-pole screw clamp (1.5mm²) for connection
with an external battery with 1.5V or 3.0V (not supplied; as an accessory available) or as an external stabilized
power supply with 1.5V / 3.0V or 24V*.
Following battery-holder configurations are possible:
1x Battery Type C or Type D (1.5V)
2x Battery Type AA / C / D parallel (1.5V)
2x Battery Type AA / C / D connected in series (3.0V)
Pin Assignment for plug:
PIN FUNCTION
1 0V / GND
2 +1.5V / +3.0V / +24V*
(* only on request)
17
Technical Data