10.3 Parameter Level
Adjusting settings
10.3.1 Activate the Parameter Level
The parameter level is activated with this key. After about 3 seconds the display shows „P01"for the first
parameter. When the button is actuated again, the corresponding parameter value is displayed, which can then
be changed. With the help of this all parameters are successfully selected.
10.3.2 Election of the Decade
With this key the decade will be advanced by a passage from left to right. The selected, changeable decade is
flashing on the display.
10.3.3 Change Value
With this key the value in the selected decade is always increased by 1 (0...9or 0/1)
10.3.4 Change Sign
With this key the sign can be changed for some parameters. (Negative sign is only possible if the value is not
ZERO)
10.3.5 Leave Parameter Level
All parameters will be retentively stored in the internal flash memory when leaving the parameter level.
Hold it for about 3 seconds / then press each 1x
1x pressed
1x pressed
Press it for about 3 seconds in the parameter level
35
Structure and Function
Structure and Function