Programing The Speed Controller; A) Programming Of Full Throttle And Neutral Position - Reely ROAD Rex-X Operating Instructions Manual

10.

Programing the Speed Controller

a) Programming of Full Throttle and Neutral Positions
If the speed controller does not react correctly to the transmitter, set the trim for the driving function correct-
ly.
If this does not help any, reprogram the full throttle positions for forward and reverse driving and the neutral
position.
• Switch off the speed controller now (switch position „OFF").
• Place the vehicle on an appropriate surface so that the wheels can turn freely.
• Switch on the transmitter and leave the throttle/brake in the centre position (neutral position). Put the trimming for
driving into the centre position.
• Move the throttle/brake lever into full throttle for forward driving (pull the throttle all the way towards the handle) and
keep it there.
• Switch on the speed controller with the on/off switch (switch position „ON"; keep the throttle/brake lever in the throttle
position.
The motor now emits fast sound signals (they are generated by the brief activation of the motor by the speed cont-
roller) and the LED at the speed controller flashes.
Wait until the LED at the speed controller flashes green quickly and the motor emits a long beep (about 1 second).
The full throttle position for forward driving is stored.
• The LED at the speed controller will now flash red. The motor will emit quick sound signals again.
Move the throttle/brake lever into full throttle for reverse driving (push the throttle away from the handle all the way)
and keep it there.
Wait until the LED at the speed controller flashes red quickly and the motor emits a long beep (about 1 second). The
full throttle position for reverse driving is stored.
• The LED at the speed controller will now flash yellow. The motor will emit fast sound signals again.
Release the throttle/brake so that it is in the neutral position. Do not move it.
Wait until the LED at the speed controller flashes yellow quickly and the motor emits a long beep (about 1 second).
The neutral position is now saved.
• Wait for a few seconds until the yellow LED remains lit.
Then the speed controller is ready for operation with the new programming.
49