Reely ROAD Rex-X Operating Instructions Manual page 47

1. Release throttle/braking lever, vehicle rolls to a halt (or does not move, if required, correct trimming), lever is in
neutral position
2. Drive forwards, slowly pull the throttle/brake lever towards the handle
Å
3. Drive forwards and then brake (vehicle slows down; does not roll to a halt slowly); push throttle/brake lever away
from the handle without stopping (to the stop)
Å
4. Drive forwards and then go into reverse (wait briefly between the change (approx. 1 - 2 seconds) and leave the
lever in its neutral position!)
Å
If the neutral position is not correct (e.g. trimming control slightly off), you cannot switch between forward
and reverse driving. If you have this problem, correct the trimming settings for the driving function at the
transmitter.
If this does not help, program the neutral position and the full throttle positions for forward and reverse and
the neutral position if required, see chapter 10 a).
Stop driving immediately if the vehicle shows any unusual responses to the remote commands or if the
vehicle does not respond at all.
The speed controller switches off the motor with the undervoltage recognition when the voltage of the driving
batteries drops too much. This protects the driving batteries from deep discharge.
Wait briefly
Æ
Æ
47