B) Programming Via The Programming Card - Reely ROAD Rex-X Operating Instructions Manual

b) Programming via the Programming Card

Use the enclosed programing card to change various settings of the speed controller easily. For this, two fully charged
2-cell LiPo driving batteries that must take over the power supply of the speed controller and programming card are
required just as for operation of the vehicle.
If there is a miniature USB socket at the bottom of the programming card, it serves only for updates by the
manufacturer. Do not connect anything here.
Proceed as follows:
• Turn off the speed controller (switch to „OFF"; see figure in chapter 9. f).
• Turn out the four screws of the receiver box lid again and take it off.
• Pull the plug of the 3-pole connection cable of the speed controller from the connection of channel 2 („CH2") of the
receiver (remember the orientation of the plug or the colours of the cable).
• Push the 3-pin plug of the speed controller into the corresponding 3-pin connection at the upper edge of the pro-
gramming card. Observe correct alignment; see coloured mark next to the connection (white = „S", red = „+",
black = „-").
• Now connect the two fully charged 2-cell LiPo driving batteries to the speed controller via the enclosed Y-recharge-
able battery adapter.
• Switch on the speed controller (switch position „ON").
• The LEDs on the programing card now show the current setting of the corres-
ponding functions (see description on the next page); the upper LED at „Cut Off
Voltage" flashes.
• If a setting is to be changed, push the button at the lower right on the programing
card several times until the LED(s) of the function that you want to change flash
(e.g. „Brakes Strength").
Now keep the button at the lower right of the programing card pushed (do not
release). The LED(s) of the function just selected switch to the next set value
(e.g. 0%........100%).
Release the button again when the desired set value is reached.
The LED(s) of the selected function flash again and you can switch to the next
function by briefly pushing the button, etc.
• If you have made all settings, switch off the speed controller. All changes made
are saved in the speed controller automatically.
• Disconnect the rechargeable batteries from the speed controller and completely
remove the plug connection.
• Connect the 3-pole plug of the speed controller to the intended connection „CH2"
at the receiver again (observe correct orientation; the black GND/mass line is
located towards the edge of the receiver).
• Re-attach the lid of the receiver box and screw it tight.
• Your vehicle can now be operated with the newly programmed speed controller.
50