Cleaning And Maintenance; Declaration Of Conformity (Doc) - Reely ROAD Rex-X Operating Instructions Manual

12.

Cleaning and Maintenance

Before cleaning or servicing, turn the speed controller off and completely disconnect the drive batteries from
the speed controller. If you have driven the vehicle before, let all parts (e.g. motor, speed controller, etc.) cool
down completely first.
Clean the whole vehicle of dust and dirt after driving, e.g. with a long-haired clean brush and a vacuum cleaner.
Compressed air aerosols can also be helpful.
Do not use cleaning aerosols or conventional household cleaners. This may damage the electronics and
lead to discolouration of the plastic parts.
Never wash the vehicle with water, e.g. using a high-pressure cleaner. This will destroy the engine, speed
controller and receiver. The vehicle must not become damp or wet!
At appropriate intervals, you should perform maintenance work and function checks on the vehicle. This
ensures trouble-free operation and road-worthiness for a long time.
Motor vibrations and shocks during driving can loosen parts and screw fittings.
Therefore, check the following items before and after driving:
• Tight fit of wheel nuts and of all vehicle screw fittings
• Attaching the speed controller
• Glue-connections of tyres and rims or tyre condition
• Attachment of all cables (they must not get into movable parts of the vehicle)
Also check the model for damage before each use. If you find any damage, the car may not be used any-
more and has to be taken out of operation.
Only original spare parts must be used to replace worn vehicle parts (e.g. tyres) or defective vehicle parts
(e.g. a broken transverse link).
13.

Declaration of Conformity (DOC)

We, Conrad Electronic, Klaus-Conrad-Straße 1, D-92240 Hirschau, hereby declare that this product adheres to the
fundamental requirements and other relevant regulations of the directive 1999/5/EC.
The compliance statement for this product is available at www.conrad.com.
62