Table of Contents
Advertisement
1
1-11 Connecting network cable to the ColorPASS
Ethernet connection
For connecting to Ethernet, the ColorPASS supports Unshielded Twisted Pair (UTP)
cabling, defined as Category 5 for use with 100BaseT; or as Category 3, Category 4, or
Category 5 for use with 10BaseT. The cable uses an 8-pin RJ-45 connector that plugs
into the RJ-45 socket on the ColorPASS.
The 100BaseT type supported by the ColorPASS is 100BaseTX, also known as
N
:
OTE
Fast Ethernet. If an Ethernet hub is used, it must be a 100BaseTX hub. The term
"100BaseT" is used to refer to 100BaseTX.
T
E
O CONNECT TO THE
THERNET BOARD
•
Connect the network cable to the RJ-45 connector on the back of the ColorPASS.
A Category 5 unshielded twisted pair cable network cable must be used for 100BaseT.
:
Advertisement
Table of Contents
