Ethernet Board; To Remove The Ethernet Board; To Replace The Ethernet Board - Canon ColorPASS-Z20e Service Manual

5.5 Ethernet board

The Ethernet board provides the interface between the ColorPASS and the customer's net-
work. The Ethernet board has one RJ-45 network connector for a 10/100BaseT unshielded
twisted pair cable. The Ethernet board is installed in motherboard connector PCI5.
RJ-45 connector

5.5.1 To Remove the Ethernet Board

1. Power off and open the ColorPASS as described in "To shut down the ColorPASS" on
page 4-4 and "To open the ColorPASS" on page 4-5.
2. Remove the board mounting bracket screw from slot 6, and then remove the Ethernet
board from motherboard connector PCI5.
Grasp the board at the front and back edge and gently pull it straight out of its connector
on the motherboard.
3. Place the board in an antistatic bag.

5.5.2 To Replace the Ethernet Board

1. Insert the Ethernet board into motherboard connector PCI5. The component side of the
board should be facing the copier
The Ethernet board connector is keyed to fit only one way when properly oriented.
2. Attach the board mounting bracket screw to the bracket in slot 6.
3. Reassemble the ColorPASS and verify its functionality (see the connection verification
steps described in "Restoring ColorPASS functionality after service" on page 4-10).
Be sure to connect the Ethernet cable to the connector in slot 6.
COPYRIGHT© 2000 CANON INC.
F04-505-01 Ethernet board connectors
2000 2000 2000 ColorPASS-Z40e/Z20e REV.0 AUG. 2000
CHAPTER 4 DISASSEMBLY/ASSEMBLY
To motherboard
connector PCI5
4-17