Port Setup Options - Canon Z5000 Configuration Manual

3
3-12 Performing Setup from the Control Panel
Exit Port Setup
Ethernet Setup
Token Ring Setup
Port Setup
Network Setup
Port Setup
Network Setup
Port Setup

Port Setup options

You can enable Ethernet and Token Ring simultaneously. To configure the
ColorPASS, choose each port type you use and enter the settings for that port. Since
network setups are nested, the names of higher-level menus are shown in this
chapter to the left of each menu heading.
Ethernet Setup
Enable Ethernet
Yes/No [Yes]
Select Yes if you have Ethernet cabling connected to the ColorPASS.
Ethernet Speed
Auto Detect/100 Mbps/10 Mbps [Auto Detect]
Select Auto Detect if your network environment is mixed, or if you do not know
the network speed. If you know the speed of the network to which the ColorPASS
is attached (10 Mbps or 100 Mbps), select it.
Token Ring Setup
Enable Token Ring
Yes/No [No]
Select Yes if the ColorPASS is to be connected to a Token Ring network.
Token Ring Speed
Auto Detect/16 Mbps/4 Mbps [Auto Detect]
Select Auto Detect if your network environment is mixed, or select the speed
(4 Mbps or 16 Mbps) of the network to which the ColorPASS is attached.
Maximum Frame Size
(bytes)
4202/2154/1130/632 [4202]
Select the maximum frame size recommended by the network administrator at your
site. If you are uncertain of the setting to use, select the default value (4202).