Canon Z5000 Configuration Manual page 93

4
4-9 Network Setup
Ethernet (Port Setup)
Enable Ethernet
Transmission Speed
select the speed (10 Mbps or 100 Mbps) of the network to which the ColorPASS is
attached.
Token Ring (Port Setup)
Enable Token Ring
Maximum Frame Size
administrator at your site. If you are uncertain of the setting to use, select the default
value (4202).
Transmission Speed
select the speed (4 Mbps or 16 Mbps) of the network to which the ColorPASS is
attached.
Enable Source Routing
Request All Routes
you want the Request packet to travel to its destination by all routes.
Respond All Routes
selected. Select if you want the Response packet to return by all routes to the
originating computer.
—Select if the ColorPASS is to be connected to an Ethernet network.
—Select Auto Detect if your network environment is mixed, or
—Select if the ColorPASS is connected to a Token Ring network.
—Select the maximum frame size recommended by the network
—Select Auto Sense if your network environment is mixed, or
—Select if your network supports source routing.
—This option is active only if you enabled Source Routing. Select if
—This option is available only if the previous option is not