About The Control Panel Setup Interface - Canon Z5000 Configuration Manual

3
3-4 Performing Setup from the Control Panel
T S
O ACCESS
1. Make sure the information screen on the Control Panel reads Idle.
2. Press the Menu button on the Control Panel to go to the Functions menu.
3. Scroll with the down arrow and press the line selection button next to Run Setup.
4. When prompted to confirm your choice, press the line selection button next to OK.
5. Press the line selection button to choose a Setup menu or command.
Exit Setup
Server Setup
Network Setup
Printer Setup
6. Perform, in order, Server Setup, Network Setup, and Printer Setup.
Setup
PS Setup
Color Setup
7. Set an Administrator password to protect your Setup from unauthorized alteration.
Job Log Setup
Change Password
Setup
C PASS
ETUP WHEN THE OLOR
If Printing or RIPping appears, the ColorPASS is processing, and you must wait
until the system finishes and reaches the Idle state.
If an Administrator password has been set on the ColorPASS, you are prompted
to enter it before you can perform Setup (see page 3-44).
Press the down button to view the remaining screens of the main Setup menu.
This is the minimum required for initial Setup. Later, you can complete the
remaining Setups either from the Control Panel or from a Windows computer.
Review the settings described in this chapter. For more information on Control
Panel menus other than those in Setup, see the Job Management Guide.

About the Control Panel Setup interface

When you perform Setup from the Control Panel, you select one menu after another
and enter information about your ColorPASS and your network and printing
environment.
In each Setup screen, the last line of the display window shows the name of the current
Setup menu. Most of the menus you see are shown on the Control Panel Map, a
flowchart that can be printed from the Control Panel.
I :
IS AT DLE