Canon Z5000 Configuration Manual page 57

3
3-21 Network Setup options
Exit IPX/SPX Setup
Select Frame Types
Clear Frame Types
IPX/SPX Setup
Exit IPX/SPX Setup
Ethernet 802.2 *
Ethernet 802.3
Ethernet II
IPX/SPX Setup
Select Frame Types
Enable IPX Auto Frame Type
Yes/No [Yes]
Specify whether the ColorPASS should try to bind to all available frame types
automatically. The ColorPASS does so whether or not all frame types are appropriate.
To determine the frame types that were successfully bound, save your changes, exit
Setup, allow the ColorPASS to reboot, and print a Configuration page. The
Configuration page lists only one of the frame types that were successfully bound.
If you answer No to this option, you can select frame types manually. You must choose
at least one frame type to enable IPX/SPX protocols.
The frame selection screen allows you to make multiple selections. Depending on your
Port Setup selection, only Ethernet frame types, only Token Ring frame types, or all
frame types are displayed.
Press the line selection button beside each frame type used on your IPX/SPX network.
An asterisk (*) appears beside each selected frame type. Press the line selection button
again to deselect a frame type. Use the up and down buttons to scroll to additional
frame types. The ColorPASS binds to each frame type as you select it.
When you have selected all the frame types used, choose Exit IPX/SPX Setup.
Clear Frame Types
You can clear all frame types at once by choosing Exit IPX/SPX Setup, then choosing
IPX/SPX Setup and selecting Clear Frame Types.