Table of Contents
Advertisement
4
4-27 Network Setup
Enable Windows (SMB) Printing Service
Block), the file and printer sharing protocol built into Windows. Enabling SMB allows
the ColorPASS to be listed on the network so that Windows clients can print to a
particular print connection (Hold, Print, or Direct) on the ColorPASS without any
other networking software. For information on how to set up a Windows client for
Windows printing, see Getting Started.
Windows (SMB) printing runs over TCP/IP, so TCP/IP must be configured on
N
:
OTE
the ColorPASS and on workstations that use Windows printing.
The remaining options are found only in remote Setup. To change them with local
Setup, use the Network Control Panel in Windows NT.
—The server name is the name that will appear on the network. It can,
Server Name
but does not have to, be the same name as the server name assigned to the ColorPASS
(see page 4-4).
—You can enter information about the printer, up to 15 characters. These
Comment
comments are listed in the Properties of the ColorPASS in Network Neighborhood.
Lowercase letters are allowed in this field.
Domain or Workgroup
appear.
Ethernet WINS Server
Token Ring WINS Server
Broadcasts from SMB devices cannot be routed beyond their original network segment
without a WINS name server. Setting up the WINS name server is outside the scope of
this manual. To find out if a name server is available, contact your network
administrator.
—Select to enable SMB (Server Message
—Enter the workgroup or domain where the ColorPASS should
—Enter the IP address of the Ethernet WINS name server.
—Enter the IP address of the Token Ring WINS name server.
Advertisement
Table of Contents
