Chapter 4 Record Settings
4.1 Configuring Encoding Parameters
4.1.1 Initializing the HDD
Before you start:
Install at least one HDD on the mobile NVR for video data storage.
Steps:
1.
Enter the HDD Management interface.
Menu>HDD
2.
Select the hard disk from the drop-down list. You can view the status, free space and capacity of the HDD.
3.
Set the overwrite mode to Yes or No to enable or disable the disk overwriting function for the selected HDD.
4.
Click the View button, and you can view the S.M.A.R.T. information of the HDD.
If the hard disk is installed correctly and formatted, the status is displayed as normal or sleeping.
The disk overwriting function is enabled by default. If the disk overwriting function is disabled, the recording will stop
when the hard disk is full.
4.1.2 Configuring Record Settings
Purpose:
You can configure the transmission stream type, the resolution, frame rate, etc.
Steps:
1.
Enter the Record Settings interface.
Menu>Basic Settings>Record
Mobile Network Video Recorder User Manual
Figure 4. 1 HDD Management
40