Table of Contents
Advertisement
2.
Check the checkbox of Motion Detection to enable the motion detection function.
3.
Click the Area Settings button to set the area for motion detection.
Perform the following steps to set a specified area for motion detection:
1)
Press the Edit key on the remote control and a red block appears on the screen.
2)
Press the Direction keys on the remote control to adjust the position of the red block.
3)
Press the Enter key on the remote control to save the position of the red block.
4)
Press the Direction keys on the remote control to adjust the size of the block.
5)
Press the Enter key on the remote control to save the size of the block.
6)
Press the Menu key on the remote control to set the detection sensitivity. You can set the level as 1~6 or off. Click
OK to save the settings.
7)
You can press the A key on the remote control to clear all the mask areas.
8)
Press the Enter key on the remote control to save the settings and then press Esc key to exit.
For mouse operations, you can click-and-drag the mouse to draw the area on the live video, right-click to set the
detection sensitivity and clear the area.
4.
Click the Handle button of Motion Detection, and you can set the arming schedule and alarm linkage actions.
Perform the following steps to set the arming schedule and alarm triggered linkage actions:
1)
Select the day from the drop-down list, and set the arming schedule for the alarm linkage actions.
2)
Optionally, you can copy the current settings to other days in the week.
3)
Check the checkboxes to enable the corresponding linkage actions.
Pop-up Image on Monitor
When an alarm is triggered, the local monitor displays the video image from the alarming channel configured for
full screen monitoring.
Audio Warning:
Trigger an audible beep when an alarm is detected.
Trigger Alarm Output:
Trigger an alarm output when an alarm is detected. For details of alarm output settings, see Chapter 7.2.2.
4)
Click the Set button of Triggered Camera to select the camera to record when the alarm is triggered.
5)
Click Apply to save the new settings and click OK to exit.
Mobile Network Video Recorder User Manual
Figure 4. 4 Motion Detection Settings
43
Advertisement
Table of Contents
