Table of Contents
Advertisement
Two periods can be configured for each day. And the time periods can't be overlapped each other.
7.2 Configuring Satellite Positioning
Purpose:
The built-in GNSS module supports both GPS (Global Positioning System) and BDS (BeiDou Navigation Satellite System,
reserved), contributing to the device positioning and speed limit alarm.
Steps:
1.
Enter the Satellite Positioning Settings interface.
Menu>Basic Settings>Position
2.
Select the mode of the Position Module. 4 modes of positioning module are selectable.
RS232: Obtain data from the satellite positioning module connected through RS232 interface.
RS485: Obtain data from the satellite positioning module connected through RS485 interface.
Built-in: Obtain data from the satellite positioning module built in the mobile NVR.
Display Terminal: Obtain data from the intelligent display terminal.
3.
Check the checkbox of Satellite Time Adjusting and then select the time zone in which the device locates.
4.
Select the speed unit and input the speed limit value.
5.
Set the linkage actions for speeding alarm, including audible warning and alarm output. For details of alarm output
Mobile Network Video Recorder User Manual
Figure 7. 2 Start Control-Auto Working
Figure 7. 3 Satellite Positioning Settings
54
Advertisement
Table of Contents
