Table of Contents
Advertisement
3.3.
After-market rear-view camera
Some vehicles have a different reverse gear code on the CAN-bus which doesn't
communicate with the interface's CAN. In this case there are two different ways of
installation. If the interface's CAN is able to detect an enabled vehicle's reverse gear, the
green wire of the 6pin to 12pin cable should carry +12V while the reverse gear is engaged.
Note: Do not forget to set dip5 of video-interface to ON before testing.
3.3.1. Case 1: Interface receives the reverse gear signal
If the interface receives +12V on the green wire of the 12pin interface cable while reverse
gear is engaged, the video interface will automatically switch to the rear-view camera input
"CAMERA-IN"
while the reverse gear is engaged.
The 12 V power supply for the rear-view camera (max 3A) has to be taken from the
12pin interface cabl's green wire
permanent power supply to the camera electronic.
Both green cables
Version 26.01.2022
"Reverse-OUT"
"Reverse IN"
and
"Reverse OUT"
HW: CAM(100)/(V20/Y+V41)
to avoid an unnecessary,
have to remain connected.
CI-RL4-SY3
Advertisement
Table of Contents
