Table of Contents
Advertisement
3.3.2. Case 2: Interface does not receive the reverse gear signal
If the video interface does not receive +12V on the green wire of the 12pin interface cable
when reverse gear is engaged (not all vehicles are compatible), an external switching signal
from the reverse gear light is required. As the reverse gear light's power supply isn't voltage-
stable all the time, an ordinary open relay (e.g AC-RW-1230 with wiring AC-RS5) or filter (e.g.
AC-PNF-RVC) is required. The diagram below shows the connection type of the relay.
Disconnect the green cable's pre-connected male- and female connectors of the
12pin cable and connect the green input cable
(87) of the relay.
Note: Not least to avoid short circuits, the best solution should be, to crimp a male
4mm connector to the relay's output cable and connect it to the green cable's female
4mm connector. The output-cable
function.
Connect the Reverse light's power-cable to coil (85) and the vehicle's ground to coil
(86) of the relay.
Connect the output connector (87) of the relay to the rear-view camera's power-
cable, like you did it to the green
Connect permanent power / 12V to the relay's input connector (30).
Version 26.01.2022
"Reverse-IN"
"Reverse-OUT"
remains disconnected as it's out of
"Reverse-IN"
cable before.
HW: CAM(100)/(V20/Y+V41)
to the output connector
CI-RL4-SY3
Advertisement
Table of Contents
