Table of Contents
Advertisement
Symptom
Camera input picture
black.
Camera power taken directly
Camera input picture
from reverse gear lamp.
has distortion.
Camera input picture
Camera input picture settings
settings cannot be
can only be adjusted in AV2
adjusted.
mode.
Graphics of a car in
Function PDC is ON in the
camera input picture.
interface OSD.
Function RET or ALL is ON
Chinese signs in
(function for Asian market) in
camera input picture
the interface OSD.
CAN-bus interface does not
Not possible to switch
support this function for
video sources by OEM
vehicle.
button.
Pressed too short.
Not possible to switch
video sources by
SW-version of interface does
external keypad.
not support external keypad.
Interface does not
CAN-bus interface does not
switch to camera input
support this function for the
when reverse gear is
vehicles.
engaged.
CAN-bus interface
Interface switches
compatibility to vehicle is
video-sources by itself.
limited.
10R-05 0068
Version 26.01.2022
Reason
Use relay or electronics to "clean" reverse gear lamp
power. Alternatively, if CAN-bus box is compatible
with the vehicle, camera power can be taken from
green wire of 6pin to 8pin cable.
Set dip 3 of video-interface to ON (if not input AV2 is
not already activated) and connect the camera to AV2.
Switch to AV2 and adjust settings. Reconnect camera
to camera input and deactivate AV2 if not used for
other source.
In compatible vehicles, the graphics will display the
factory PDC distance. If not working or not wanted, set
interface OSD menu item UI-CNTRL to ALLOFF.
Set interface OSD menu item UI-CNTRL to ALLOFF or
PDCON.
Use external keypad or cut white wire of 6pin to 8pin
cable and apply +12V impulses for AV-switching.
For video source switching a longer press of about 2.5
seconds is required.
Use OEM-button or cut white wire of 6pin to 8pin
cable and apply +12V impulses for AV-switching.
Cut the green wire of the 6pin to 8pin cable and apply
+12V constant from reverse gear-lamp signal. Use
relay to "clean" R-gear lamp power.
Cut the grey wire of 6pin to 8pin and isolate both
ends. If problem still occurs, additionally cut the white
wire of 6pin to 8pin cable and isolate both ends.
Made in China
HW: CAM(100)/(V20/Y+V41)
Possible solution
CI-RL4-SY3
Advertisement
Table of Contents
