Table of Contents
Advertisement
2.6.
Installation with analogue connection (without CAN bus)
If, after connecting the PNP harness, no interface LED lightens up while the ignition is turned
on, the interface must also be connected in analogue mode.
Connect the female 12pin connector of the 12pin interface cable to the male 12pin
connector of the video interface.
Connect the 12pin interface cable's purple coloured wire
to
S-contact terminal 86s +12V
Version 26.01.2022
(e.g. glove compartment illumination).
HW: CAM(100)/(V20/Y+V41)
Manual ACC
to+12V ACC
CI-RL4-SY3
or
Advertisement
Table of Contents
