Connection Pnp Power / Can Cable - NavLinkz r.LiNK CI-RL4-SY3 Manual

Compatible with ford vehicles with sync3 full version with apim 7inch or 8inch, tablet or non-tablet monitor.

Table of Contents

2.4.2. Connection PNP power / CAN cable

The APIM module is located behind the centre console or behind the glove box.

Connect the enclosed PNP Power / CAN cable's female10pin connector to the male

10pin connector of the video interface.

Disconnect the female 54pin connector of the vehicle harness at the rear side of the

APIM module and connect it to the male 54pin connector of the enclosed PNP

Power/CAN cable.

Connect the enclosed PNP Power / CAN cable's opposite female54pin connector to

the previously become free male 54pin connector of the APIM module.

Version 26.01.2022

HW: CAM(100)/(V20/Y+V41)

CI-RL4-SY3

Table of Contents