Installation With Analogue Connection (Without Can-Bus) - NavLinkz RL4-NAC12 Manual

2.3.3. Installation with analogue connection (without CAN-Bus)

Connect the female 20pin connector of the 20pin interface cable to the male 20pin
connector of the video interface.
Connect the 20pin interface cable's white wire "Manual ACC" to +12V
contact terminal 86s +12V
Note: In case the analogue connection has to be made (because some vehicles are not
compatible), the input signal for each connected video source must also be manually
triggered via the corresponding 4 trigger lines
Trig-REAR/Trig-FRONT/Trig-RIGHT/Trig-LEFT
For analogue connection, don't forget to set dip4 to OFF!
Version 29.11.2022
(e.g. glove compartment illumination).
HW: BOT(V43)(V54)
ACC or to +12V S-
RL4-NAC12