Set Comware-Memory - H3C MSR 810 Command Reference Manual

Examples
# Specify boot order number 1 for disk hda on VM centos7.
<Sysname> system-view
[Sysname] vmm
[Sysname-vmm] set bootorder vm centos7 target hda 1

set comware-memory

Use
set comware-memory
Comware system.
Syntax
set comware-memory size
Default
A minimum of 3 GB of physical memory is available for the Comware system.
Views
VMM view
Predefined user roles
network-admin
Parameters
size size
GB.
Usage guidelines
This command is supported only on the following routers:
•
MSR3610-I-DP.
•
MSR3610-I-XS.
•
MSR3610-IE-DP.
•
MSR3610-IE-XS.
Make sure the Comware system is allocated a minimum of 2 GB of physical memory. In addition, the
amount of physical memory allocated to the Comware system cannot exceed (the total amount of
physical memory on the device - 2) GB.
The amount of physical memory available for the Comware system equals the total amount of
physical memory on the device minus the amount of physical memory occupied by all VMs. As a best
practice to avoid memory conflicts, set the minimum amount of physical memory available for the
Comware system to a proper value.
For this command to take effect, you must save the configuration and reboot the device.
Examples
# Reserve a minimum of 2 GB of physical memory for the Comware system.
<Sysname> system-view
[Sysname] vmm
[Sysname-vmm] set comware-memory 2
Comware reserved memory size has been changed, please reboot the router to make
the configuration take effect.
Comware reserved memory size has been setted lower than default value 3G, and it
may be insufficient to use.
to set the minimum amount of physical memory available for the
: Sets the minimum amount of physical memory available for the Comware system, in
24