Irf Priority - H3C MSR 810 Command Reference Manual

Parameters
member-id
new-member-id
Usage guidelines
CAUTION:
IRF member ID change can invalidate member ID-related settings, including interface and file path
settings, and cause data loss. Make sure you fully understand its impact on your live network.
To have the new ID take effect, you must reboot the IRF member. To cancel the member ID change
before you reboot the member device, use the
command, set the new member ID to be the same as the old member ID.
When adding a device into an IRF fabric, you must assign a unique IRF member ID to the device. If
its IRF member ID has been used in the IRF fabric, the device cannot join the IRF fabric.
Interchanging member IDs between IRF member devices might cause undesirable configuration
changes and data loss. For example, the IRF member IDs of Device A and Device B are 2 and 1,
respectively. After you interchange their member IDs, their port settings also interchange.
To set the member ID of a device in standalone mode, use the
Examples
# Change the ID of an IRF member device from 1 to 2.
<Sysname> display irf
[Sysname] irf member 1 renumber 2
Renumbering the member ID may result in configuration change or loss. Continue?[Y/N]Y
# Before rebooting the device, cancel the change in the preceding example.
[Sysname] undo irf member 1 renumber
Renumbering the member ID may result in configuration change or loss. Continue?[Y/N]y
If you reboot the device after executing the
member ID changes to 2 at system reboot. Using
the member ID to 1. You must use the
member ID.
Related commands
irf member

irf priority

Use
irf priority
Use
undo irf priority
Syntax
irf priority priority
undo irf priority
Default
The IRF member priority is 1.
Views
System view
: Specifies the ID of an IRF member. The member ID can be 1 or 2.
: Assigns a new ID to the IRF member. The member ID can be 1 or 2.
to assign an IRF member priority to a device in standalone mode.
to restore the default.
undo irf member renumber
irf member 1 renumber 2
undo irf member 1 renumber
irf member 2 renumber 1
19
command. In the
command.
irf member
command, the device
cannot restore
command to reconfigure the