Chassis Maintenance; Inspecting The Seat Belt - Toro Reelmaster 7000-D Operator's Manual
4-wheel drive traction unit
Hide thumbs
Also See for Reelmaster 7000-D:
- Service manual (468 pages) ,
- Operator's manual (144 pages) ,
- Installation instructions (2 pages)
Table of Contents
Advertisement
Backlapping the Cutting Units (continued)
2. Wash all lapping compound off of the cutting units.
3. Adjust the cutting unit reel-to-bedknife as needed.
4. Rotate the backlap levers to the F (mow) position.
Backlap lever (front cutting units 4, 1, and 5)
Backlap lever (rear cutting units 2 and 3)
5. For a better cutting edge, run a file across the front face of the bedknife after lapping.
Note:
edge.
6. Close and latch the hood.
Chassis Maintenance
Inspecting the Seat Belt
1. Inspect the seat belt for wear, cuts, and other damage. Replace the seat belt(s) if any
component does not operate properly.
2. Clean the seat belt as necessary.
3466-706A
This removes any burrs or rough edges that may have built up on the cutting
G425519
Forward rotation (mow)
Page 6–49
Maintenance: Chassis Maintenance
Advertisement
Table of Contents
