Chapter 1: Introduction; Replacement Process Overview; Required Tools - Overland Storage NEO 8000 Remove & Replace Instructions

A Horizontal Robotics Assembly (HRA) is installed inside two connected NEO 8000 libraries
to enable the robotics in each of the individual libraries to exchange cartridges by means of
a pass-through system.
IMPORTANT: Overland Storage recommends that the HRA be replaced by an Overland Storage
authorized service provider. Improper removal and replacement may result in damage to this
part or library components which would void all existing warranties.

Replacement Process Overview

Described below are the major steps required to remove and replace the HRA in your NEO
8000 system. Unless otherwise noted, all hardware is included in the HRA kit.
NOTE: Always retain any screws removed during this procedure. They will be reused to reinstall
the appropriate components.
Step 1: Prepare the Libraries
• Only if necessary, move the library system to provide working room.
• Remove both side panels for easy access to change out the HRA.
• Optionally, remove access panels at the rear of the libraries.
Step 2: Replace the HRA
• Disconnect all the library wiring from the HRA.
• Remove the old HRA from the libraries.
• Install the new HRA into the libraries.
• Replace all components removed to allow access to the HRA.
Step 3: Verify the HRA Operation
• Power On both units
• Test the HRA operational ability.

Required Tools

These tools are required for the proper removal and replacement of the HRA:
• #1 and #2 Phillips Screwdrivers
• #2 Stubby Phillips Screwdriver
These tools are required only if you need to level the libraries:
• 6" or 10" Spirit Level (15cm or 25cm)
• 36" Level with Straight Edge (90cm)
• 10" Adjustable Wrench (260mm)
Part Number 104372-102 08/2005

Chapter 1: Introduction

1–1