Attach The New Hra; Figure 3-2: Screws Holding The Hra To The Mounting Brackets; Figure 3-3: Hra Positioned Above The Mounting Bracket Assemblies - Overland Storage NEO 8000 Remove & Replace Instructions

Figure 3-2: Screws Holding the HRA to the Mounting Brackets

4. Carefully lift the HRA up and off the Mounting Bracket alignment pins.
5. Remove the old HRA from the library system and set it on a secure surface.

Attach the New HRA

Attach the new HRA to the Mounting Bracket assemblies.
1. Feed the HRA through the libraries above the Mounting Bracket assemblies.
CAUTION:

Figure 3-3: HRA Positioned Above the Mounting Bracket Assemblies

2. Guide the HRA onto the alignment pins on the Mounting Bracket assemblies.
3. Loosely secure the HRA to each Mounting Bracket assembly with a M4x10mm PH
screw.
3–2
M4x10mm Screws
Be careful not to damage the sensors mounted on the brackets.
Part Number 104372-102 08/2005