Move The Library Back In Place; Appendix A: Moving The Library; Figure A-2: Positioning The Level - Overland Storage NEO 8000 Replacement Instruction

Z-axis robotics retrofit
Hide thumbs Also See for NEO 8000:
Table of Contents

Advertisement

Appendix A: Moving the Library

6. Using at least 2 people, roll the library system to an open location.
Continue with the standard removal and replacement of the Z-Axis BDAs.

Move the Library Back in Place

Once the new BDAs are in place, you can move the library back to its original position.
1. Using at least 2 people, roll the library back in place, aligning the levelers with the
appropriate reference marks on the floor.
2. Using a wrench, turn each leveler 3-4 turns clockwise until it makes firm contact with
the floor and lines up with the reference marks.
NOTE: Be sure the library has been raised high enough so none of the casters touch the floor.
3. Place a level, front to rear, on the top side edge of the library
4. Note the position of the bubble. Raise both of the front legs or both of the rear legs the
same amount to achieve a level front-to-rear reading.
5. Place the level across the top front edge of the library.
6. Note the position of the bubble. Raise both of the left feet or both of the right feet the
same amount to achieve a level side-to-side reading.
7. Recheck the level from front-to-rear and from side-to-side. Adjust as needed until the
library is level.
A–2
Part Number 104380-101 09/2005

Figure A-2: Positioning the Level

(Figure
A-2).

Advertisement

Table of Contents
loading

Table of Contents