Purpose of This Manual
This Remove & Replace guide provides instructions and information required for the
removal and replacement of the Overland Storage Horizontal Robotics Assembly (HRA) in a
NEO 8000™ Library system comprised of two library units.
Manual Organization
The following information is contained in this manual.
Chapter 1, "Introduction."
Provides an overview of the change-out process, along with a brief description of any
additional recommendations.
Chapter 2, "Prepare the Libraries."
Describes how to open up the libraries to facilitate the removal and replacement of the HRA.
Chapter 3, "Replace the HRA."
Discusses the processes needed to remove and replace the HRA.
Chapter 4, "Verify the HRA Operation."
Covers the processes to power up the libraries and verify that the replacement was a
success.
About this Guide
This Remove & Replace guide describes how to change out your HRA in a NEO 8000. It
assumes you are familiar with basic functions of your computer and networking.
Part Number 104372-102 08/2005
Preface
iii