Canon DIM-462 Instruction Manual page 146

Miscellaneous
E
Problem
? The wireless controller does not work.
? The power indicator is flashing.
? There are air bubbles inside the lens.
? The camcorder malfunctions.
? The DV cable is connected correctly, but
there's nothing in the display.
? The camcorder becomes warm during
use.
146
Cause and/or what to do about it
• The remote sensor mode is set to OFFB in
the menu ( 30).
• The remote sensor modes of the wireless
controller and the camcorder itself are different
( 30).
• The batteries are dead or not inserted.
• Check the screen displays (
• This is unlikely, but may happen if you use the
camcorder in places where the air pressure is
low, in an airplane for example. The bubbles will
disappear a week or so after you return the
camcorder to normal atmospheric pressure.
• External interference may cause the camcorder's
microprocessor to malfunction temporarily. If
random letters appear in the display or if normal
operation is interrupted, remove and then
replace the power source.
• Remove the cable and then reconnect it or turn
the power off and back on again.
• This is not a malfunction.
137).