Table of Contents
Advertisement
USER MANUAL
2.2 Memory Module (SO-DIMM) Installation
The IV70 SBC Motherboard has two 204-pin SODIMM slot. The socket supports
up to 8GB DDR3L 1333/1600 SDRAM.
When installing the memory unit, please follow the steps below:
1. Firmly insert the SO-DIMM at an angle of about 30-degree into the slot.
Align the SO-DIMM with the slot until it is fully inserted. The notch on the
SO-DIMM should match the break on the slot.
2. Press downwards on SO-DIMM until the retaining clips at both ends fully
snap closed and the SO-DIMM is properly seated.
CAUTION
The SO-DIMM only fits in one correct orientation. It will cause
permanent damage to the development board and the SO-DIMM if
the SO-DIMM is forced into the slot at the incorrect orientation.
CHAPTER 2
10
HARDWARE INSTALLATION
Advertisement
Table of Contents
