Solder Side; Memory Module (So-Dimm) Installation - Winmate IT70 User Manual

Mini-itx sbc with intel 11th gen core i5 processor, hdmi, display port, lvds, dual giga ethernet, usb 3.2 gen 2 x1, and ngff interface

Table of Contents

2.1.3 Solder Side

The IT70 SBC Motherboard has two 260-pin SODIMM slot. The socket supports DDR4. When

installing the memory unit, please follow the steps below:

1. Firmly insert the SO-DIMM at an angle of about 30-degree into the slot. Align the SO-DIMM with

the slot until it is fully inserted. The notch on the SO-DIMM should match the break on the slot.

2. Press downwards on SO-DIMM until the retaining clips at both ends fully snap closed and the

SO-DIMM is properly seated.

CAUTION

The SO-DIMM only fits in one correct orientation. It will cause permanent damage to

the development board and the SO-DIMM if the SO-DIMM is forced into the slot at

the incorrect orientation.

Chapter 2: Hardware Installation

Table of Contents