Memory Module (So-Dimm) Installation - Winmate IW32 3.5 SBC User Manual

18 IW32 3.5" SBC User Manual

2.2 Memory Module (SO-DIMM) Installation

IW32 3.5" SBC
The
When installing the memory unit, please follow the steps below:
1. Firmly insert the SO-DIMM at an angle of about 30-degree into the slot. Align the
SO-DIMM with the slot until it is fully inserted. The notch on the SO-DIMM should match
the break on the slot.
2. Press downwards on SO-DIMM until the retaining clips at both ends fully snap closed
and the SO-DIMM is properly seated.
CAUTION
The SO-DIMM only fits in one correct orientation. It will cause permanent
damage to the development board and the SO-DIMM if the SO-DIMM is
forced into the slot at the incorrect orientation.
AVERTISSEMENT
Le SO-DIMM ne tient que dans une seule orientation correcte. Cela causera
des dommages permanents à la carte de développement et au SO-DIMM si
le SO-DIMM est forcé dans l'emplacement avec une orientation incorrecte.
has two 260-pin SODIMM slot. The socket supports DDR4.