I/O Equipment Installation; Dc-In; Ps/2 Keyboard And Ps/2 Mouse; Serial Com Port - Winmate IV70-130 User Manual

USER MANUAL CHAPTER 2 HARDWARE INSTALLATION

2.3 I/O Equipment Installation

2.3.1 12V DC-IN
The Motherboard allows plugging 12V DC-IN DIN-4 connector on the board
without another power module converter under power consumption by Intel
Socket G2 processor in HM76 with Intel® 7 series chipset.
*Without power/reset OSD, short circuit pin 5 and 6 together to boot up the
motherboard (Front Panel Connector).

2.3.2 PS/2 Keyboard and PS/2 Mouse

The Motherboard provides two PS/2 interface. The PS/2 connector supports
Keyboard 7 IV70 Motherboard User Manual and Mouse. In other cases, especially
in embedded applications, a mouse is not used. Therefore, the BIOS standard
setup menu allows you to select* "All, But Keyboard" under the "Halt On". This
allows no-keyboard operation in embedded system applications without the
system halting under POST.

2.3.3 Serial COM Port

Three RS-232 connectors build in the rear I/O. Fourth optional COM ports support
RS-232. When an optional touch-screen is ordered with PPC, serial com port can
connect to a serial or an optional touch-screen. One optional COM port supports
RS232/422/485 choice through jumper setting.

2.3.4 Internal VGA

The Motherboard has one VGA port that can be connected to an external CRT/
LCD monitor. Use VGA cable to connect to an external CRT / LCD monitor, and
connect the power cable to the outlet. The VGA connector is a standard 15-pin
D-SUB connector.

2.3.5 Ethernet Interface

The Motherboard is equipped with Broadcom BCM57780 chipset which is fully
compliant with the PCI 10/100/1000 Mbps Ethernet protocol compatible. It is
supported by major network operating systems. The Ethernet ports provide two
standard RJ-45 jacks.
11