22
IK32-300 SBC User Manual
2.2 Memory Module (SO-DIMM) Installation
The IK32 SBC Motherboard has two 260-pin SODIMM slot. The socket supports DDR4.
When installing the memory unit, please follow the steps below:
1. Firmly insert the SO-DIMM at an angle of about 30-degree into the slot. Align the SO-DIMM
with the slot until it is fully inserted. The notch on the SO-DIMM should match the break on
the slot.
2. Press downwards on SO-DIMM until the retaining clips at both ends fully snap closed and
the SO-DIMM is properly seated.
NOTE:
Pull tabs away with your thumbs, bracing your forefingers against the rails. The
memory module will be released. Then raise the memory module to a vertical position.
CAUTION
The SO-DIMM only fits in one correct orientation. It will cause permanent damage to
the development board and the SO-DIMM if the SO-DIMM is forced into the slot at
the incorrect orientation.