USER MANUAL
2.2 Memory Module (SO-DIMM) Installation
The ID31 Motherboard provides one 204-pin SODIMM slot. The socket supports up
to 4GB DDR3 1066 SDRAM.
When installing the –memory unit, please follow the steps below:
1. Firmly insert the SO-DIMM at an angle of about 30-degree into the slot. Align the
SO-DIMM with the slot until it is fully inserted. The notch on the SO-DIMM should
match the break on the slot.
2. Press downwards on SO-DIMM until the retaining clips at both ends fully snap
closed and the SO-DIMM is properly seated.
CAUTION
The SO-DIMM only fits in one correct orientation. It will cause
permanent damage to the development board and the SO-DIMM if the
SO-DIMM is forced into the slot at the incorrect orientation.
ID31 MOTHERBOARD
CHAPTER 2
HARDWARE INSTALLATION
10