User Manual
2.1.2 I/O Side
2.2 Memory Module (SO-DIMM) Installation
The IV70 SBC Motherboard has two 204-pin SODIMM slot. The socket supports up to
8GB DDR3L 1333/1600 SDRAM. When installing the –memory unit, please follow the
steps below:
Step 1 Firmly insert the SO-DIMM at an angle of about 30-degree into the slot. Align
the SO-DIMM with the slot until it is fully inserted. The notch on the SO-DIMM
should match the break on the slot.
Step 2 Press downwards on SO-DIMM until the retaining clips at both ends fully snap
closed and the SO-DIMM is properly seated.
CAUTION
The SO-DIMM only fits in one correct orientation. It will cause
permanent damage to the development board and the SO-DIMM if the
SO-DIMM is forced into the slot at the incorrect orientation.
IV70 Motherboard
Chapter 2
Hardware Installation
8