Table of Contents
Advertisement
USER MANUAL
2.3.6 USB Port
Eight USB devices (four with pin headers) may be connected to the system
though an adapter cable. Various adapters may come with USB ports. USB
usually connect the external system to the system. The USB ports support hot
plug-in connection. Whatever, you should install the device driver before you use
the device.
2.3.7 Audio Jack ( Pin-header)
The Audio 5.1 channel capabilities are provided by a Realtek ALC886 chipset
supporting digital audio outputs. The audio interface includes Mic-in,: line-in and
line-out.
2.4 Jumper Settings
This section explains how to set jumpers for correct configuration of the
motherboard.
NOTE:
A pair of needle nose pliers may be helpful when working with
jumpers. If you have any doubts about the best hardware
configuration for your application, contact your local distributor or
sales representative before you make any changes. Generally, you
simply need a standard cable to make most connections.
The jumper setting diagram is shown below. When the jumper cap is placed on
both pins, the jumper is SHORT. The illustration below shows a 3-pin jumper; pins
1 and 2 are short. If you remove the jumper cap, the jumper is OPEN.
CAUTION
To avoid damaging the module, always turn off the power supply
before setting jumpers or clearing CMOS.
CHAPTER 2
PIN 1-2 SHORT
PIN 3 OPEN
12
HARDWARE INSTALLATION
Advertisement
Table of Contents
