Installing The Base Using Latch - GB IDAN User Manual

BefoRe installing base,
make sure vehicle is on
level ground. place base
on an approved latCh
vehicle seating location.
1
Remove latCh anchors
from storage. to access
the latCh Connector
storage compartments,
squeeze the level
adjustment handle to fully
extend the leveling foot.
2
Remove each connector by pushing the red
button while pulling out.
3
Unfold the load leg from underneath the Base.
4
position Base on a rear vehicle seat. if a hump is
present on the floor of the vehicle, see page 34
for important information on the limits of using
the load leg in this seating position.
5
adjust the leveling foot to achieve the correct
angle for your child's weight as shown on the
level indicator. see page 37.
38

InStallInG the baSe USInG latCh

1 2
5
4
3