GB IDAN User Manual page 43

5
pull out vehicle belt to form a single length
of about 24 inches (60 cm). hold the buckle
tongue in one hand and squeeze the lap and
shoulder belts together in the other.
Route the vehicle belts under the Belt
6
tensioning plate, and through the Belt guides
on both sides of the Base. BUckle the
Belt. make sure the belts lay flat and are not
twisted.
the vehicle belt should alWays be routed
UndeR the tab on the Belt guide. neveR
place a vehicle belt over the tab on the Belt
guide, even in a vehicle with longer buckle
stalks.
on the buckle side, first lift up on the shoulder
7
belt to remove slack in the lap belt
remove slack from the shoulder belt on the
opposite side .
b
at this point, only remove slack from the
vehicle belts, being careful not to over
tighten them. the Belt tensioning plate will
tighten the system fully. if you have previously
installed the seat using latch, make sure
the latch strap lies flat on the bottom of the
Base. see "to store" section on page 33.
. then
a
7
a
5
24 inches
60 cm
6
b
43