GB IDAN User Manual page 47

5
Route the lap belt under the Belt tensioning
plate, and through the Belt guides on both
sides of the base. BUckle the Belt. Remove
slack from the lap belt and make sure the belt
lies flat and is not twisted.
the vehicle belt should alWays be routed
UndeR the tab on the Belt guide. neveR
place a vehicle belt over the tab on the Belt
guide, even in a vehicle with longer buckle
stalks.
make sure the vehicle lap belt is locked.
at this point, only remove slack from the
vehicle belt. the Belt tensioning plate will
tighten the system fully. if you have previously
installed the seat using latch, make sure
the latch strap lies flat on the bottom of the
Base. see "to store" section on page 33.
6
tuck the loose end of the lap belt under
the base, so it's out of the way and does
not inteRfeRe with the closing of the Belt
tensioning plate or the connection of the
infant carrier to the Base.
5
6
loose end of lap belt
47