GB IDAN User Manual page 40

InStallInG the baSe USInG latCh
9
press the Belt tensioning plate down with both
9
hands, where indicated, until it locks into place.
the orange locking lever will rotate to the
close position automatically when the plate is
locked.
if Belt tensioning plate does not lock, try
loosening the latch strap slightly.
automatic
do not turn
10
grab the Base at the Belt guides and pull from
side to side and front to back to make sure it is
installed correctly. the base should not move
more than 1 inch (2.5 cm) in any direction.
if the Base moves too much, open the Belt
tensioning plate, tension the latch strap a
10
little more and try again. after this, if the Base
still moves too much, you may need to try a
different vehicle seat location or installation
method, or both.
40