GB IDAN User Manual page 44

InStallInG the baSe USInG a lap and ShoUlder belt
8
press the Belt tensioning plate down with both
hands where indicated, until it locks into place. the
orange locking lever will rotate to the close
position automatically when the plate is locked.
if Belt tensioning plate does not lock, try loosening
the vehicle belt slightly.
9 grab the Base at the Belt guides and pull from side
to side and front to back to make sure it is installed
correctly. the Base should not move more than 1
inch (2.5 cm) in any direction.
if the Base moves too much, open the Belt
tensioning plate and remove a little more slack from
the vehicle belt, close plate and recheck. after this, if
the Base still moves too much, you may need to try a
different vehicle seat location or installation method,
or both.
in most vehicles, you can switch the shoulder belt
retractor into locking mode by pulling out shoulder
belt all the way and then letting it rewind into the
retractor. pull on the belt to make sure it is locking.
neveR install this child restraint using a non-locking
vehicle lap shoulder belt. a locking clip must be
used with a vehicle belt that does not lock. call
gB at 1.844.543.2020 to obtain a locking clip.
44
8
automatic
do not turn
9