Parameter Setting - Okura Yusoki A Series Original Instructions Manual

5.6. Parameter setting (Controller data)
The directory to
setting screen is as follows.
System storage menu
↓
Controller data
↓

Parameter setting

１．Job number
・ Enter the job number you work
on.
・The job number is shown up at
the basic menu.
２．Top of latch range
・ The range on and after the
device No. is set becomes
latched.
３．Number of I/O board
・Number of RC502 boards to be
used is set.
４．IP address
・IP address, Net mask and default gateway of RC501 board are set.
５．Touch panel (POD) IP address
・IP address to be set to touch panel is set.
parameter
5-9