Password Setting; Memory Switch - Okura Yusoki A Series Original Instructions Manual

5.4. Password setting

In standard setting, the password setting is necessary only at the time of system storing.
Password setting can also be done with each screen of setting for auto operation, teaching
and conveyor data.
The directory is as follows.
System storage menu
↓
Controller data
↓
Password setting
[ Procedure for storing ]
①Select an item to be set by
pressing a key
②Input 4 passwords
③Press Set key
[Procedure for resetting]
①Select an item to be reset by pressing a key
②Press Clear key
Note
The memory switch 1-5 is turned on to make this setting effective.
- As the standard password is master one, it still works even after the system
storing

5.5. Memory Switch

The directory to memory switch screen is as follows.
System storage menu
↓
Controller data
↓
Memory switch
- Set the memory switch inside robot.
(Normally, no change is necessary.)
- The following items are set by turning
memory switches ON and OFF.
-For changing, press a switch to be
changed then turn it ON and OFF.
- Descriptions come out in the bottom frame upon pressing the numeral key in left side
5-5