JDS Uniphase T-BERD ⁄ MTS 5800 Series Getting Started Manual page 66

Chapter 3 System Tools
Accessing the T-BERD ⁄ MTS 5800 remotely
44
a Do one of the following:
– If you are using a browser that supports VNC, point
the browser to the IP address of the unit by typing into
the address bar, including the VNC port number
(5800). For example, http://192.168.0.1:5800.
– If you have a third-party VNC viewer, launch VNC
viewer, and then enter the T-BERD ⁄ MTS 5800's IP
address, and then select OK.
The prompt for a password appears, if one is set, or the
T-BERD ⁄ MTS 5800 user interface appears in the VNC
viewer.
6 If the message, "Failed to connect to server" appears, the
VNC viewer was not able to communicate with the
T-BERD ⁄ MTS 5800. If this happens, try the following
solutions:
– Make sure you are using the correct IP address for the
T-BERD ⁄ MTS 5800.
– From the PC or laptop, ping the T-BERD ⁄ MTS 5800
IP address to verify the network link is working. If the
link is not working, restart the T-BERD ⁄ MTS 5800 and
repeat step 2
7 After you have connected to the T-BERD ⁄ MTS 5800
from a laptop or PC using the VNC viewer, use the
computer's mouse to control the T-BERD ⁄ MTS 5800.
8 To end a remote operation session, do one of the
following:
– On the PC or laptop running the VNC viewer, end the
VNC session.
– Power cycle the T-BERD ⁄ MTS 5800 (turn off then
back on)
T-BERD/MTS 5800 Getting Started Manual
through step 5.