JDS Uniphase T-BERD ⁄ MTS 5800 Series Getting Started Manual page 157

Glossary
Symbols/Numerics
10G — Used on the connector
panel to represent
10 Gigabit Ethernet.
10GE — Used on the connector
panel to represent
10 Gigabit Ethernet.
10GigE — Used throughout this
manual to represent
10 Gigabit Ethernet.
802.11b — IEEE standard for
wireless LANs. You can estab-
lish wireless LAN connections to
the T-BERD ⁄ MTS 5800 using
an 802.11 adapter.
A
AC — Alternating Current. An
AC power adapter is supplied
with the T-BERD ⁄ MTS 5800.
T-BERD/MTS 5800 Getting Started Manual
B
BER — Bit Error Rate.
BERT — Bit error rate test. A
known pattern of bits is trans-
mitted, and errors received are
counted to figure the BER. The
Bit Error Rate test is used to
measure transmission quality.
D
DHCP — Dynamic Host Config-
uration Protocol. A communica-
tions protocol that assigns IP
addresses dynamically as
needed. The test instrument
supports static IP address
assignment.
135