JDS Uniphase T-BERD ⁄ MTS 5800 Series Getting Started Manual page 27

Table 1 T-BERD ⁄ MTS 5800 configurations
Catalog Number
TB/MTS-5801
TB/MTS-5802
TB/MTS-5812
TB/MTS-5801P
TB/MTS-5802P
TB/MTS-5812P
NOTE:
Some configurations also require you to purchase and install cer-
tain testing options; others require specific hardware connectors to
connect to circuits for testing. For example, if your instrument does
not have a connector designed to support 1GigE Optical testing,
you can not transmit and analyze a signal or traffic over a 1GigE
circuit.
You can quickly determine whether or not your instrument sup-
ports certain applications by exploring the technologies, rates, and
test modes presented on the Test menu and by reviewing the set-
tings available when you configure a test.
Table 1 describes the available configurations.
Configuration
T-BERD ⁄ MTS 5800 Single Port Test set
T-BERD ⁄ MTS 5800Dual Port Test set
T-BERD ⁄ MTS 5800
T-BERD ⁄ MTS 5800
T-BERD ⁄ MTS 5800
T-BERD ⁄ MTS 5800
To discuss a specific configuration or to order accessories for
your T-BERD ⁄ MTS 5800, contact JDSU Customer Care or
your regional sales office. Contact information for regional
sales headquarters is provided on the back cover of this
manual. You can also contact JDSU through the company
web site, www.jdsu.com.
T-BERD/MTS 5800 Getting Started Manual
10G and Dual Port Test set
Single Port Test set with PDH
Dual Port Test set with PDH
10G and Dual Port Test set with PDH
Chapter 1 Introduction
Configurations
.
5